COMPRO NC3230 Installationsanleitung PDF herunterladen (Seite 10)

Compro NC3230 - Installation Guide

Installation

Re-routing Terminal Cable

If necessary, you can have the terminal cable exit from the bottom of the camera. To do

so, remove the camera’s top cover rst and go ahead to detach the entire terminal cable

, along with the plastic cable gland, from the camera. Then unscrew the plastic conduit

entry cover on the bottom. Fasten the plastic cable gland to the bottom conduit entry,

and thread the terminal cable through the bottom conduit entry, and then connect the

cables to the camera’s connectors. Finally, screw the plastic cover you’ve removed from

the camera’s bottom into the side conduit entry.

Side Conduit

Entry

Cable Gland

Bottom Conduit

Entry

Connect the Cables

Basic Cabling

The gure below shows the basic cabling of your IP camera.

1. LAN cable from PC to hub/router: If your LAN cable from PC has been connected

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Keine Kommentare

COMPRO NC3230 Installationsanleitung Seite 10